fuzztfork8

QUICK HP MOLD GUIDE
11
06:40

QUICK HP MOLD GUIDE

For Lee 4-20 pot, you need around 1.5 inch riser with the NOE hollow point mold fuzztfork8Began reloading in 1976; casting in 1977 when good lead wheel weights were everywhere..There is something about making your own and being self-sufficient, that intrigued me.

I had an Uncle Jim day

Tried the New NOE HOLLOW POINT MOULD. Put in long pins for deeper point, changed to a shorter pin as wasn't coming out as I intended. Mould had been cleaned and smoked, went up and down with temp, no avail. Finally added a softer alloy which did the trick.

MAIL CALL-THANKS

  I want to thank AL NELSON, Full lead Taco, Loads of Bacon, and all of my buddies who reload. I am almost positive they let me win to shut me up!! Shipping was quick, the chat was on 3/20, Taco contacted me on 3/21 to pick a mould, and it arrived on 3 /23. […]

Deer-Rain-Casting

  All day rain, had to do something.   fuzztfork8Began reloading in 1976; casting in 1977 when good lead wheel weights were everywhere..There is something about making your own and being self-sufficient, that intrigued me.

Cooking with Fuzzy

Put your apron on and follow me… fuzztfork8Began reloading in 1976; casting in 1977 when good lead wheel weights were everywhere..There is something about making your own and being self-sufficient, that intrigued me.

Reloading manuals

  These books are your most important item you could have on hand; other than old fashion Common sense. You will need both however !!   fuzztfork8Began reloading in 1976; casting in 1977 when good lead wheel weights were everywhere..There is something about making your own and being self-sufficient, that intrigued me.

A deer plaque

  a present from an old man   fuzztfork8Began reloading in 1976; casting in 1977 when good lead wheel weights were everywhere..There is something about making your own and being self-sufficient, that intrigued me.